EndRun FDC3302, User Manual

Page: 32 / 46

F D C 3 3 0 2 U s e r M a n u a l 22
A P P E N D I X C
23 F D C 3 3 0 2 U s e r M a n u a l
N E T W O R K P O R T O P T I O N
Available User Commands
In addition to the commands described in Chapter 3 - Control and Status Commands , when your
FDC3302 is configured with the Network Port Option, these commands are also available.
COMMAND FUNCTION
netconfig Configures the IP network addressing parameters.
netmac Shows the Media Access Control (MAC), or ethernet, address
of the network port.
netpass Sets the password for accessing the network port via Telnet or
SSH. Default password is endrun_1.
netprotocol Sets the protocol for accessing the network port - either Telnet
or SSH.
netreset Resets the network port.
netsnmp Turns SNMP on or off.
netsnmpro Sets the SNMP read-only community string.
Default read-only community string is fdc_user.
netsnmprw Sets the SNMP read-write community string.
Default read-write community string is endrun_1.
All entered commands are assumed to be terminated with a carriage return. Line feeds are ignored.
All responses from the FDC3302 are terminated with a carriage return and a line feed.
Detailed Command
Descriptions
netconfig
This command queries or sets the IP network addressing parameters that are stored in FLASH. After
setting new addresses, enter the
netreset
command for these settings to take effect on the network
port. Command syntax is:
netconfig=d,i,n,g,p,s
d is ON or OFF to enable or disable DHCP.
If DCHP is ON, then enter the command as:
netconfig=ON
. No other fields are necessary.
If DHCP is OFF, then enter these remaining fields:
i is the IP Address 111.222.333.444
n is the Netmask 111.222.333.444
g is the Gateway Address 111.222.333.444 or hyphen ‘-’ if you are not using one.
p is the primary DNS Address 111.222.333.444 or hyphen ‘-’ if you are not using one.
s is the secondary DNS Address 111.222.333.444 or hyphen ‘-’ if you are not using one.
In the example below the user is disabling DHCP and setting the IP address, netmask, gateway and
the primary DNS address. The secondary DNS is not used.