EndRun FDC3302, User Manual

Page: 24 / 46

F D C 3 3 0 2 U s e r M a n u a l 14
C H A P T E R T H R E E
15 F D C 3 3 0 2 U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
Command:
return
Chassis response:
OK
(The chassis will return to the primary input.)
selectedin
This query-only command shows the currently selected signal input, either A, B or NONE.
Query:
selectedin
Chassis response:
A
(Currently selected input is Signal Input A.)
settings
This query command displays all user command settings.
Query:
settings
Chassis response:
disablemode = Y,Y,ON
port = 57600,8,N,1
respmode = VERBOSE
switchmode = AB
siginstat
This query-only command shows the current status of both Signal Inputs A and B. The first character
is for Signal Input A and the second character is for Signal Input B. A ‘0’ means a signal is not pres-
ent and a ‘1’ means a signal is present.
Query:
siginstat
Chassis response:
10
(Signal Input A is present. Signal Input B is not.)
sigoutstat
This query-only command shows the current status of Output Signals 1 though 10. The first charac-
ter is for Output 1, the second is for Output 2, and so on. A ‘0’ means there is no input signal, the out-
put driver is bad or a short is connected to it. A one ‘1’ means there is an input signal and the output
signal is good.
Query:
sigoutstat
Chassis response:
1011111111
(A problem exists at Output 2.)
status
This command displays the results of all status query commands.
Query:
status
Chassis response:
alarm = 00000x 0000000000 000x
disablestat = 00
pwrstat = 10
selectedin = A
siginstat = 11
sigoutstat = 1111111111