EndRun FDC3302, User Manual

Page: 33 / 46

F D C 3 3 0 2 U s e r M a n u a l 22
A P P E N D I X C
23 F D C 3 3 0 2 U s e r M a n u a l
N E T W O R K P O R T O P T I O N
Set:
netconfig = OFF,192.168.1.135,255.255.255.0,192.168.1.1,192.168.1.1,-
Chassis response:
OK
Reset network port (“netreset”) for these settings
to take effect.
Query:
netconfig
Chassis response:
netconfig = OFF,192.168.1.135,255.255.255.0,192.168.1.1,192.168.1.1,0.0.0.0
Factory default setting:
netconfig = ON
NOTE
If using DHCP, in addition to the IP address and netmask, ensure that the DHCP server also assigns a gate-
way, or Telnet and SSH may not connect.
netmac
This is a query-only command shows the Media Access Control (MAC) address of the ethernet network
port.
Query:
netmac
Chassis response:
netmac = 0:20:4a:94:32:ae
netpass
This command sets the password for accessing the network port via Telnet or SSH. The password must
be at least 8 and less than 32 characters. Characters must be alphanumeric or the underscore ‘_’. Enter-
ing control-C will quit without changing the password. There is no query mode for this command.
Set:
netpass
Chassis response: System prompts user for the password.
Factory default password:
endrun_1
netprotocol
This command sets or queries for the protocol used for accessing the network port. Choices are either
Telnet or SSH. Syntax is: netprotocol=x, where x is either Telnet or SSH.
Set:
netprotocol=ssh
Chassis response:
OK
Query:
netprotocol
Chassis response:
ssh
Factory default setting:
telnet