Endress ESE 604 DHG DIN, Translation Of The Original Operating Instructions

Page: 37 / 92

Operate power generator ESE 604 DHG DIN
Status at: October 2018 ESE 604 DHG (ES) DIN
37
1. Push the lever on the fuel valve
❷
up to the left stop
(closed).
2. Open cover flap above the tank Fig. 3-3-
❷ .
3. Unscrew tank cover Fig. 3-3-
❶
.
4. Insert filler aid into the filler neck.
5. Add petrol.
6. Remove filler aid.
7. Screw on tank cover

The device is refuelled.
4.4
Starting the generator
Proceed as follows to start the generator.
The following requirements must be met:

Electrical safety check (see 6.3)

Fuel tank has been filled (see 4.3)

A possibly connected fuelling device (special accessory)

sufficient oil level (fill with engine oil before initial use, see
the engine operating and maintenance instructions)

ventilation must be adequate.

Fit push-on exhaust gas pipe (special accessory) if
needed

a connected and operational starter battery

Appliances switched off or disconnected
WARNING!
Operating fluids can burn or explode.

Prevent leaking of engine oil and petrol.

Do not use starting aids.

Avoid open flames and sparks.
Requirements