Operate power generator ESE 604 DHG DIN
Status at: October 2018
ESE 604 DHG (ES) DIN
45
4.8
Monitoring the operating status using the multifunction
display
All LEDs light up for about 2 seconds to allow checking as
soon as the START-STOP switch
is set to the position “Oper-
ate”. The normal operational lighting is then shown afterwards
for about 30 seconds. If the engine is not started within this
period, the E-MCS 4.0 goes into energy saving mode and the
indicator goes dark. To bring the E-MCS 4.0 back into a ready-
to-operate condition again, the START-STOP switch must first
be turned into the position “STOP”. The display intensity is de-
pendent on the ambient brightness
(sensor
see Fig. 4-5-(5)
).
Fig. 4-6: Multi-functional display
The display
(Fig. 4-6-(1))
is active when the generator starts or
is activated for 30 seconds when the START / STOP switch
is turned to the “Operate” position.
If the display is red
(see Fig. 4-6-(16))
whilst the generator is
running, the temperature is too high and the generator must
be switched off.
If the display
(see Fig. 4-6-(15))
lights up red whilst the genera-
tor is running, the oil pressure is too low and the generator
switches automatically or the buzzer sounds; this can be
acknowledged using the acknowledgement button.
(Buzzer only active for the ordered “Insulation monitoring without switching
off“ special fitting)
Operating hours:
Ambient temperature:
Oil pressure:
Summary of Contents for ESE 604 DHG DIN
