Endress+Hauser Proline Promag H 500, Operating Instructions Manual

Page: 115 / 240

Proline Promag H 500 PROFIBUS DP Commissioning
Hauser 115
Fixed current →  115
Damping output 1 to n →  116
Failure mode →  116
Failure current
→  116
Parameter overview with brief description
Parameter Prerequisite Description User interface /
Selection / User
entry
Factory setting
Terminal number – Shows the terminal numbers
used by the current output
module. • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
• 20-21 (I/O 4) –
Signal mode – Select the signal mode for the
current output. • Passive
• Active Active
Assign current output 1 to n – Select process variable for
current output. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Temperature
*
• Electronic
temperature
Volume flow
Current span – Select current range for
process value output and
upper/lower level for alarm
signal. • 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
• 0...20 mA
• Fixed current Country-specific:
• 4...20 mA NAMUR
• 4...20 mA US
0/4 mA value One of the following options is
selected in the
Current span
parameter (→  115):
• 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
• 0...20 mA
Enter 4 mA value. Signed floating-point
number Country-specific:
• 0 l/h
• 0 gal/min (us)
20 mA value One of the following options is
selected in the
Current span
parameter (→  115):
• 4...20 mA NAMUR
• 4...20 mA US
• 4...20 mA
• 0...20 mA
Enter 20 mA value. Signed floating-point
number Depends on country
and nominal
diameter
Fixed current The Fixed current option is
selected in the Current span
parameter (→  115).
Defines the fixed output
current. 0 to 22.5 mA 22.5 mA