Endress+Hauser Proline Promag H 500, Operating Instructions Manual

Page: 119 / 240

Proline Promag H 500 PROFIBUS DP Commissioning
Hauser 119
Minimum frequency value →  119
Maximum frequency value →  119
Measuring value at minimum
frequency →  120
Measuring value at maximum
frequency
→  120
Failure mode →  120
Failure frequency →  120
Invert output signal
→  120
Parameter overview with brief description
Parameter Prerequisite Description Selection / User
interface / User
entry
Factory setting
Operating mode – Define the output as a pulse,
frequency or switch output. • Pulse
• Frequency
• Switch Pulse
Terminal number – Shows the terminal numbers
used by the PFS output
module. • Not used
• 24-25 (I/O 2)
• 22-23 (I/O 3)
• 20-21 (I/O 4) –
Signal mode – Select the signal mode for the
PFS output. • Passive
• Active Passive
Assign frequency output The Frequency option is
selected in the Operating
mode parameter (→  117)
parameter.
Select process variable for
frequency output. • Off
• Volume flow
• Mass flow
• Corrected volume
flow
• Flow velocity
• Conductivity
*
• Corrected
conductivity
*
• Temperature
*
• Electronic
temperature
Off
Minimum frequency value The Frequency option is
selected in the Operating
mode parameter (→  117)
and a process variable is
selected in the
Assign
frequency output parameter
(→  119).
Enter minimum frequency. 0.0 to 10 000.0 Hz 0.0 Hz
Maximum frequency value The Frequency option is
selected in the Operating
mode parameter (→  117)
and a process variable is
selected in the
Assign
frequency output parameter
(→  119).
Enter maximum frequency. 0.0 to 10 000.0 Hz 10 000.0 Hz