Basic safety instructions
Liquitrend QMW43
6
Hauser
1.3
Documentation
For an overview of the scope of the associated Technical Documentation, refer to the
following:
•
W@M Device Viewer
(
from nameplate
•
Hauser Operations App
: Enter the serial number from the nameplate or
scan the 2D matrix code (QR code) on the nameplate
1.4
Registered trademarks
is a registered trademark of the IO-Link company group.
2
Basic safety instructions
2.1
Requirements for the personnel
The personnel must fulfill the following requirements to carry out the necessary tasks,
e. g., commissioning and maintenance:
‣
Trained, qualified specialists must have a relevant qualification for the specific function
and task
‣
Are authorized by the plant owner/operator
‣
Are familiar with federal/national regulations
‣
Must have read and understood the instructions in the manual and supplementary
documentation
‣
Follow instructions and comply with conditions
2.2
Designated use
Improper use can pose hazards
‣
Ensure that the measuring device is free of defects while it is in operation
‣
Use the measuring device only for media to which the process-wetted materials have
an adequate level of resistance
‣
Do not exceed or undershoot the relevant limit values of the measuring device → see
the "Technical data" section
2.2.1
Incorrect use
The manufacturer is not liable for damage caused by improper or non-designated use.
Clarification of borderline cases:
‣
For special materials and media used for cleaning, the manufacturer is happy to
provide assistance in verifying the corrosion resistance of medium-wetted materials,
but disclaims any warranty or liability.
Residual risks
Due to heat transfer from the process, the temperature of the electronics housing and the
assemblies contained therein may rise to 80 °C (176 °F) during operation.
Danger of burns from contact with surfaces!
‣
If necessary, ensure protection against contact to prevent burns.
