Endress+Hauser Liquiline CM442R, Operating Instructions Manual

Page: 52 / 172

Commissioning Liquiline CM442R/CM444R/CM448R
52
Hauser
9.3 Basic setup
Making basic settings
1. Go to the "Setup/Basic setup" menu.
Make the following settings:
2. Device tag: Give your device any name of your choice (max. 32 characters).
3. Set date: Correct the set date if necessary.
4. Set time: Correct the set time if necessary.
For quick commissioning, you can ignore the additional settings for outputs , relays etc. You can
make these settings later in the specific menus.
5. Return to the measuring mode, by pressing and holding the soft key for "ESC" for at least one
second.
 Your controller now works with your general settings. The sensors connected use the
factory settings of the sensor type in question and the individual calibration settings that
were last saved.
If you want to configure your most important input and output parameters already in the "Basic
setup", proceed as follows:
‣
Configure the current outputs, relays, limit contactors, controllers, device diagnostics and
cleaning cycles with the submenus which follow the time setting.