Endress+Hauser Fieldgate FXA520, Operating Instructions Manual

Page: 85 / 108

Fieldgate FXA520 7 Viewing Information (User Mode)
Hauser 83
Table 7-11: Modem log messages
No Signal! GSM The GSM module does not have any reception
signal
Pin Ok GSM SIM Pin is OK
User defined AT: <at-cmd> Modem/GSM User-defined AT commando output
FAILED: timeout Modem/GSM Command at modem triggered a timeout
FAILED: <modem-response> Modem/GSM Command at modem returned an unexpected
response
OK: <modem-response> Modem/GSM Command at modem returned an expected
response
GSM operator: <operator> signal = <signal
strength>
GSM Output of current GSM operator and signal strength.
In order to ensure stable GSM operation the signal
strength should be > 15
FAILED: no data call GSM Incoming call to Fieldgate without data connection
=> vocal call
selected GSM operator denied, GSM Engine
switched to automatic mode
GSM Manually set GSM Provider is not valid for the SIM
card in use
cannot connect to selected GSM operator
connected to: <Provider>
or:
cannot connect to selected GSM operator, GSM
Engine switched to automatic mode
GSM The GSM Modem cannot connect to the manually
entered provider. Possible reasons are a weak signal.
The Fieldgate has connected to an alternative
provider. In this case the GPRS connections are
suppressed.
Pin xxxx ist not correct-> ERROR GSM An attempt has been made to enter the PIN as xxxx,
which is presumably not the correct code.
Last retry to set a correct PIN GSM After the next incorrect attempt to enter the PIN,
the SIM card is locked
no PIN is set -> please set PIN under Modem
Configuration
GSM No pin number entered in GSM setup dialog, see
Chapter 5.4.2
no SIM card in device GSM SIM card not inserted in device
SIM card error -> <errorcode> GSM Problem in logging in the GSM modem
SIM PUK required GSM The SIM card is locked and can only be unlocked by
entering the PUK .
connecting to GPRS permanently /
connecting to GPRS
GSM A GPRS connection is being made
GPRS Network: <APN> GSM Indicates APN with which the modem is connected
GPRS-QOS: not set/use defaults GSM Quality of Service parameter not set, Fieldgate takes
standard parameter of SIM card.
incoming ring during connect (GPRS Client) /
incoming ring during connect (Client)
GSM Incoming call detected during current GPRS/ISP
connection
GPRS hangup requested by incoming call GSM The current GPRS connection is interrupted for 5
minutes for an incoming call. To build up a data call,
a second call must be made, see Chapter 5.4.2.
Auto detection of available GSM bands GSM Indicates automatically available GSM bands
<band>MHz ok GSM Indicates which GSM Band has been selected
connection to test server failed or invalid test
server
GSM Connection could not be made to test server. In this
case the GPRS connection is made again. Possible
reasons: the GPRS connection has failed or the
server settings arre invalid
dial in to ISP <phone number> permanently /
dial in to ISP <phone number>
GSM/Modem ISP connection is being made
daily dial-in time of <xy>min exceeded! GSM/Modem The max. daily dialing time of xy min via ISP was
exceeded. Next possible connection at midnight or
24 hours after message, depending upon settings.
daily traffic limit of <xy>kByte exceeded! GSM The max. daily traffic limit of xy Kbyte via GRS was
exceeded. Next possible connection at midnight or
24 hours after message, depending upon settings.
error during modem initialization GSM/Modem No modem could be found
GSM Engine: <Hersteller>, <Modell> GSM Indicates which modem was found
Modem log message Connection Meaning