Fastlane
®
Pro Swim Unit Installation
Fastlane
®
Pro Swim Unit Installation
Cut the center portion out of the bracket using the etched marks in the brackets as a guide. The two end
portions will be used as washers on the backside of the pool wall (Fig 4.25).
Fig. 4.25
Insert the threaded rod into each PVC washer making sure there is a flat washer and jam nut on the back-
side of the PVC washer (Fig 4.26 DETAIL A). Position and install each PVC washer and threaded rod as-
sembly against the backside of the pool wall. Adjust the hardware on the threaded rods so that they extend
approximately 1-1/2” (38mm) into the pool. Install an additional flat washer and jam nut onto each threaded
rod on the inside of the pool (Fig 4.26 DETAIL B).
Fig. 4.26
24
