ENCAD CADJET, Service Manual

Page: 42 / 164

3-4 Maintenance
CadJet 3D Service Manual
4. Using a cotton swab dampened with distilled water, wipe the
seals and the rubber wiper in the service station until no more
ink residue or dust can be removed.
5. With a dry swab, wipe all moisture from the seals and wipers.
6. Close the lid and reconnect the power cord and interface cable.
7. If the service station is filling with ink or very dirty it can be
removed and rinsed under warm water. To remove, pull the tab
on the right side of the service station and lift out. Wash, dry
thoroughly and replace by placing the left side in first then
pushing down on the right side until the tab locks it in place.
Linear Encoder Strip Cleaning
Clean the linear encoder strip weekly or as necessary to remove any
buildup of debris. Distilled water or isopropyl alcohol may be used. You
may notice that it tends to fog the encoder strip; however, no detrimen-
tal effect has been observed in the field.
To clean the Encoder Strip:
1. Disconnect the power cord and interface cable.
2. Slightly dampen a cotton swab with distilled water or isopropyl
alcohol and wipe along the length of the encoder strip on both
sides.
3. Reconnect the power cord and interface cable.