ENCAD CADJET, Service Manual

Page: 139 / 164

CadJet 3D Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-39
6. Remove the Stabilizer Bracket from the Y-Arm Assembly by
removing the four alignment Allen screws and washers located
on the back of the Y-Arm Assembly.
The Encoder Strip is not a field removable item. The
entire Stabilizer Bracket Assembly with the Encoder
Strip and Trailing Cable installed is to be replaced if
the Encoder Strip is damaged.
Install the Stabilizer Bracket and Encoder Strip
1. Install the Stabilizer Bracket Assembly (with Encoder Strip and
Trailing Cable) onto the Y-Arm Assembly using the four
alignment Allen screws and washers. Hand tighten only.
2. Install the Support Bracket onto the Stabilizer Bracket Assembly
by placing the Support Bracket onto the Stabilizer Bracket with
a slight forward tilt.
3. Perform the Install the Carriage Assembly, Carriage Belt, and
the Frame Tensioner Procedures to install the Carriage
Assembly, Carriage Belt, and the Frame Tensioner.
4. Perform steps 2 through 7 of the Install the Trailing Cable
Assembly procedures to finish installing the Trailing Cable
Assembly.
5. Perform the Install the Ink Delivery System procedures to install
the Ink Delivery System.
6. Perform the Install the Left, Top, and Right Covers procedures to
install the Left, Top and Right Covers.
7. Perform the Head Height Adjustment procedures found in
Chapter 3 of this service manual.