ENCAD CADJET, Service Manual

Page: 136 / 164

5-36 Assembly\Disassembly
CadJet 3D Service Manual
Install the Service Station
1. To install the Service Station, position the Service Station inside the
Right Cover and place the left side of the Service Station into the
Platen.
2. Push down on the right side of the Service Station until the Service
Station snaps into place.
3. Slide the Carriage Assembly to the right and back into the home
position. Lower the Top Cover.
Remove the Trailing Cable Assembly
1. Perform steps 1 through 13 of the Remove the Left, Top, and Right
Covers procedures to remove the Left, Top and Right Covers.
2. If you have not already removed the Carriage Assembly from the
Slide Shaft, you will need to perform Steps 3 through 7 of the
Removing the Carriage Assembly, Carriage Belt, and the Frame
Tensioner procedures in order to remove the Electronics Cover and
release the left end of the Trailing Cable from the Carriage PCB.
3. Disconnect the Trailing Cable Assembly connector at the J6 location
on the MPCB. Use the thumb and forefinger to pull forward on the
connector lock and remove the Trailing Cable from the connector.
See Figure 3-6 if necessary.
4. The Trailing Cable Assembly is secured to the Stabilizer Bracket by
two pieces of double sided tape. Remove the Trailing Cable
Assembly from the Stabilizer Bracket.
5. Remove the ferrite and the tape securing it to the Trailing Cable.