ENCAD CADJET, Service Manual

Page: 127 / 164

CadJet 3D Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-27
4. Make sure the left end of the Trailing Cable extends out beyond
the left end of the Trailing Cable Support Assembly.
5. Slide the Carriage Assembly onto the left end of the Slide Shaft,
making sure that the Encoder Strip fits into the slot in the Slider
and the Encoder on the Carriage PCB. Guide the belt while
sliding the Carriage Assembly from left to right on the Slide
Shaft.
6. Move the Carriage Assembly to the left end of the Slide Shaft and
align the left bushing on the Carriage Assembly with the left end
of the Slide Shaft.
7. Insert the Strain Relief (with Trailing Cable) onto the Carriage
Assembly by sliding it onto the Strain Relief Support until it
snaps firmly into place. See Figure 5-13.
8. Place the Trailing Cable into the J1 connector lock on the
Carriage PCB. Make sure the silver fingers on the Trailing Cable
are fully inserted into the lock and slide both sides of the
connector lock shut at the same time.
9. Place the right side of the back of the Electronics Cover under the
Trailing Cable Support Assembly and gently press down on the
ends of the Electronics Cover until the latches snap into the
Carriage Assembly.
10. Slide the Carriage Assembly to about the middle of the Slide Shaft
and stretch out the Carriage Belt.
11. Insert the Carriage Belt into the Frame Tensioner so that the belt
extends about an inch past the Frame Tensioner.
12. Holding the Carriage Belt and Frame Tensioner, insert the Idler
Pulley Assembly into the loop of the belt. Make sure that the side
of the Idler Pulley Assembly with the thicker outer ring of plastic
is facing up. See Figure 5-13.