ENCAD CADJET, Service Manual

Page: 117 / 164

CadJet 3D Service Manual
ASSEMBL
Y
/
DISASSEMBL
Y
Assembly\Disassembly 5-17
5. Insert and hold the Power Supply into place while securing it with
four screws. Torque to 15 in-lbs.
6. Reconnect the Power Supply to the AC Entry Module by reattaching
the quick disconnect connection. Push the quick disconnect
assembly behind the Power Supply Bracket and out of sight.
7. Perform steps 1 through 14 of the Install the MPCB procedure to
install the MPCB.
8. Perform steps 4 through 10 of the Install the Left, Top, and Right
Covers procedure to install the Right and Top Covers.
Remove Servo Motor
1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
2. Perform steps 3 through 13 of the Remove the MPCB (Main Printed
Circuit Board) procedure to disconnect all connectors from the
MPCB.
3. Reach between the Power Supply Bracket and the AC Entry Module
and carefully pull out the quick disconnect assembly attaching the
Power Supply input to the AC Entry Module. Disconnect the Power
Supply input from the AC Entry Module.
NOTE
The following procedure will leave the MPCB and Power
Supply still attached to the Power Supply Bracket. For
this procedure there is no reason to remove these assem-
blies from the Power Supply Bracket.
4. Using a #2 Phillips screwdriver, remove the screw securing the
ground strap from the MPCB to the side plate.
5. Using a #2 Phillips screwdriver, remove the four screws securing
the Power Supply Bracket to the Right Baseplate. Remove the
Power Supply Bracket.