82
Appendix - Regulatory Compliance
Safety and Regulatory Information
The Spectrum Analyzer connected with an Ethernet cable to the Personal Computer (PC) must all
together comply with CE emission requirements
•
Read all of the instructions listed here and/or in the user manual before you operate this device. Give
particular attention to all safety precautions. Retain the instructions for future reference.
•
This device must be installed and used in strict accordance with manufacturer’s instructions, as
described in the user documentation that is included with this device.
•
User must comply with all warning and caution statements in the instructions. Observe all warning
and caution symbols that are affixed to this device.
•
To prevent shock or fire hazard, do not expose this device to rain or moisture. The device must not be
exposed to dripping or splashing. Do not place objects filled with liquids or chemicals on the device.
•
This device was qualified under test conditions that included the use of the specified cables, between
system components. To ensure regulatory and safety compliance, use only the provided power and
interface cables and install them properly.
•
Different types of cord sets may be used for connections to the main supply circuit. Use only a main
line cord that complies with all applicable device safety requirements of the country of use.
•
Installation this device must be in accordance with national wiring codes and confirm to local power
company instructions and guidelines.
•
Do not overload outlets or extension cords, as this can result in a risk of fire or electric shock.
Overloaded AC outlets, extension cords, frayed power cords, damaged or cracked wire insulation,
and broken plugs are dangerous. They may result in a shock or fire hazard.
•
Route power supply cords so that they are not likely to be walked on or pinched by items placed upon
or against them. Pay particular attention to cords where they are attached to plugs and convenience
receptacles, and examine the point where they exist from the device.
•
Place this device in a location that is close enough to an electrical outlet to accommodate the length
of the power cord.
•
Place the device to allow for easy access when disconnecting the power cord of the device from the
AC wall outlet.
EMxpert Software
Appendix - Regulatory Compliance
