![background image](http://html1.mh-extra.com/html/empire-comfort-systems/millivolt-standing-pilot-dvx36fp31l-4/millivolt-standing-pilot-dvx36fp31l-4_installation-instructions-and-owners-manual_2403951039.webp)
39357-0-1018
Page 39
FOLLOW CORRECT OPTION ACCORDING TO VENTING METHOD.
Connecting Directly to Fireplace
If the air inlet and flue outlet tubes are to be connected directly to
the unit (no rigid venting system is being used), then the gasket
provided must be used to seal the 4” (102mm) flue outlet tube. Peel
the paper off the self-adhesive gasket and then wrap it around the
end of the tube (if tube was cut, it is recommended to use cut end)
as shown in
Figure 58.
Pull the gasket tight at all times while wrap-
ping it around tube. The gasket ends should align, to form a com-
plete seal. The overlapped section should NOT come in contact
with the seam in the tube. Apply high temperature sealant to the
opposite end of the tube (on the inside of the tube). The end with
the gasket will attach to the back of the unit. Continue with Step 13.
PARTS LIST
INDEX
NUMBER
PART
NUMBER
DESCRIPTION
1
DV769
Vent Cap Assembly
2
19193
Outside Mounting Plate
3
19194
Air Inlet Tube
4
DV524
Flue Outlet Tube
5
19196
Firestop/Thimble Assembly
6
20527
Gasket
DvvK-4RE vENT KIT INSTALLATION INSTRUCTIONS
(CONT'D)
Connecting to Rigid Vent System
If the air inlet and flue outlet tubes are to be connected to a
rigid venting system (and not directly to the back of the unit), then
do not
use the gasket provided. High temperature sealant should
be applied to the outside of the 4” diameter (102mm) flue outlet
tube (if tube was cut, it is recommended to use cut end) and to
the inside of the tube on the end that connects to the vent cap.
Continue with step 13.
Summary of Contents for MILLIVOLT STANDING PILOT DVX36FP31L-4
Page 52: ...39357 0 1018 Page 52 LOG PLACEMENT 12 Place Log I on the two left pins of Log B as shown below...
Page 54: ...39357 0 1018 Page 54 LOG PLACEMENT 14 Place Log K on far right pin of Log B as shown below...
Page 57: ...39357 0 1018 Page 57 LOG PLACEMENT 17 The log assembly is now complete...