ETS1 ver. 1.22
MENU SYSTEM
The display on the ETS1 has 7 lines and up to 20 symbols. Three keys on each side
of the display control the various menu choices. In addition the keypad has
numerical keys and comma, plus 4 set keys.
'Menu'
- in or out of menu modus
'Clear'
- deletes the last symbol or leaves the menu
'On/Off'
– turns on or off the ETS1 (hold for 5 sec. to turn off)
'Enter'
- accepts choices
Normal use
You start the ETS1 by pressing the '
On/Off
' key. Two seconds later you will see
version number, battery status and clock. You will also hear clicking sounds from
the unit – the eLine loops’ drives, which are automatically adjusted every time the
ETS1 is turned on. When the start procedures are done (ca. 5 sec.) the display will
show what time it is (HH:MM:SS), how many tags that are registered (zero when
the unit is started anew) and to which code the ETS1 is set (usually code 70 when
used for split times).
If the external eLine loop is not connected, you will be asked the following
question:
«Do you want to use the internal eLine?»
Answer ’Ja’ (Yes) if you want to use the internal eLine loop. Note that this loop’s
range is merely 3 metres. Answer ‘Nei’ (No) if you want to connect an external
eLine loop.
Check that the LEDs for loop1 og loop2 have the right colours (green for use of
double loops = code 248) and that all cables are connected.
The ETS1 is now ready for use if you don’t wish to change any of the standard
settings.
Page
8
Summary of Contents for ETS1
Page 25: ...ETS1 ver 1 22 Page 25 ...
