Chapter 2 Preliminary Before Installation 7
SmartCabinet Integrated Solution User Manual
Floating nut hook
Fastener
Vertical pole
Figure 2-3 Schematic diagram 2 for installing floating nut
Other installation tools
Other installation tools are shown in Figure 2-4. See Table 2-1 for their usage.
Utility knife
Cross head screwdriver
Movable wrench
Gradienter
Figure 2-4 Other installation tools
Table 2-1 Usage of other installation tools
Name
Usage
Utility knife
Disassemble the package
Cross head screwdriver
Tighten the screws when assembling the components. Recommended size: 1 × 300
Movable wrench
Adjust the feet. Recommended size: 250mm × 30mm (length × max. hatch width)
Gradienter
Display the level state when adjusting the cabinet
Vacuum pump
Used for pipe vacuum during AC installation process
2.2 Fittings
The fittings are shown in Figure 2-5; See Table 2-2 for their usage.
Floating nut
M5 countersunk head screw
M6 panel screw
M6 pan head screw
Cable tie fixture kit
Figure 2-5 Fittings
Table 2-2 Usage of fittings
Name
Usage
Floating nut
Use together with M6 screw, used to install the parts in the cabinet
M5 countersunk head screw
Used to install the cabinet connector
M6 panel screw
Used to install the power distribution unit, monitoring system and user equipment
M6 pan head screw
Used to connect and fix the frame
M6 flange nut
Use together with M6 pan head screw, used to install the L fastener
Adhesive tape
Used to seal the gap between the connected frames
Cable tie fixture kit
Used to fix and bind the cables
2.3 Accessories
See Table 2-3 for the accessories.