32 Chapter 3 Installation
SmartCabinet Integrated Solution User Manual
1 2 3 4 5 6
DIP
ON
0 1 1 1 0 1
OFF: Fixed
ON: User
Group Num
Note: 1. DIP switch in the ON position means 1,
or it means 0;
2. The sensor address cannot be set as 00,
which is the broadcast address.
Figure 3-32 Set the 4DI sensor address through DIP switch
Table 3-9 DIP list for setting the 4DI sensor address
Device
DIP1 ~ DIP4
Group
DIP5
Number
DIP6
Connected equipment type
4DIF
0 0 0 0
0
1
1
0
0
Note
The DIP addresses of the temperature sensor and the 4DIF sensor have been set before delivery. This section only serves for you
to confirm them in field.
3.9 Cable Management And Installation Accessories
The cabinet is configured with two vertical cable organizers in the rear door area, one is at left and the other is at right,
as shown in Figure 3-15. To avoid system interference, the power cable and the communication cable should be
bound separately by using optional accessories such as velcro strip, standard cable management unit.
Note
1. The U height space which is not occupied by equipment should be covered by the dummy panel.
2. After the cable layout is completed, use sealant to seal the used cable entry holes, to keep the cabinet be airtight.
The optional accessories of the cabinet are given in Table 3-10.
Table 3-10 Optional accessories
Name
Description
Appearance
Velcro strip without installation
base
The length is 4.56m; it is
recommended to configure
two for each cabinet
Cable
management
panel
Vertical cable
organizer
Managing the cable at the
rear of the cabinet in vertical
direction, meanwhile, the
gourd-shaped hole can be
used to install PDU
1U Cable
management
panel
Tool-less installation mode;
arranging the cables at the
front and back of 19
’’
cabinet
horizontally
Installation hole (2 pcs)
2U Cable
management
panel
Tool-less installation mode;
arranging the cables at the
front and back of 19
’’
rack
horizontally
Installation hole (4 pcs)
2U Cable
management
panel with
cable entry
holes
Tool-less installation mode;
arranging the cables
horizontally or from front to
back
Installation hole (4 pcs) Cable entry hole (4 pcs)