Emerson Rosemount Clarity II T56, Reference Manual

Page: 35 / 60

5 Program the transmitter
5.1 General programming information
Typical programming steps include the following listed procedures. You can easily and
quickly accomplish each of these programming functions using the intuitive menu system.
• Configure and assign values to the current outputs.
• Set a security code for two levels of security access.
• Access menu functions using a security code.
• Enable and disable Hold mode for current outputs.
• Choose the frequency of the AC power (needed for optimum noise rejection).
• Reset all factory defaults, calibration data only, or current output settings only.
5.2 Configuring and ranging current outputs
The transmitter accepts inputs from two sensors and has four analog current outputs.
Ranging the outputs means assigning values to the low (0 or 4 mA) and high (20 mA)
outputs.
Important
Always configure the outputs first.
To configure the outputs, press
ENTER/MENU
to go to
Program
→
Outputs
. You can set
Outputs 1 - 4 to Analog, PID, or Simulation. You can also set output assignments, scaling
the range, linear or logarithmic outputs, output dampening, output setpoints, and output
fault levels for each output if desired.
Reference Manual Program the transmitter
00809-0100-3565 July 2020
Rosemount T56 35