Chapter 8 Options 57
Liebert
®
ITA 5kVA And 6kVA UPS User Manual
3. Use a screwdriver to remove the two M3 × 8 screws, which fix the LED display panel and the UPS chassis. Pull out
the LED display panel and cables from the chassis, as shown in Figure 8-18 (b). Disconnect the three cables
connecting to the LED display panel, and remove the LED display panel.
4. Connect the three cables to the LCD display panel, and fix the LCD display panel with two M3 × 8 screws, as shown
in Figure 8-18 (c).
5. Install the plastic panel to its position, as shown in Figure 8-18 (d).
Remove the plastic panel
A
处
Plastic panel
LED display panel
LCD display panel
M3
×
8
screw (2 pcs)
a
b
d
c
Remove the M3
×
8 screw,
remove the LED display
panel
Install the LCD display
panel, fix it with M3
×
8
screw
M3
×
8
screw (2 pcs)
Figure 8-72 Installing the LCD display panel
Note
1. There is no need to open the USP chassis cover in process of replacing the LCD display panel.
2. Note the screw position and clip on the other side when installing and removing the display panel assembly. During installation,
first put the clip on the side of the display panel into the UPS chassis, then fix the screws; when removing the display panel, reverse
the procedures.
3. The rotation method of the LCD display panel is the same as that of the LED display panel, please refer to
2.4.1 Tower
Installation.
8.9 UF-BSO-0050 ITA UPS Battery Shared Module
The UF-BSO-0050 ITA UPS battery shared module (battery shared module for short) is only applicable to 5kVA long
back-up UPS parallel system. Through the battery shared module, a battery string of large capacity can supply power
to several 5kVA UPSs at the same time.
The appearance of the battery shared module is shown in Figure 8-19. See Table 8-10 for its description.
Ventilation
hole
Display panel
Figure 8-73 Appearance of battery shared module
