Maintenance and Troubleshooting Manual
Section 3: Meter maintenance
3-9000-772 Rev B
January 2018
Installing the shrouds
73
2.
One end of the clamped band shroud assembly has two holes which will engage guide
pins and rectangular shaped holes. Assemble one nut end of a worm screw clamp into
one of these rectangular holes.
Figure 3-26 Band shroud assembly
•
Insert the "T" shaped end of the clamp part into the rectangular shaped hole and
rotate the clamp part so the flat surface opposite of the nut is flat against the
outside surface of the band shroud. Extend the nut end of the clamp part beyond
the end of the band shroud. Once in place use tape to keep the clamp part
positioned. Repeat to install the additional three worm screw clamp parts into the
rectangular hole near the other guide pin hole. Be sure the tape used does not
cover the guide pin holes.
3.
The other end of the clamped band shroud assembly receives the threaded parts of the
worm screw clamps.
•
Insert the "T" shaped end of a threaded clamp part into into the rectangular shaped
hole and rotate the clamp part so the flat surface opposite of the nut is flat against
the outside surface of the band shroud. Extend the length of the clamp part threads
beyond the end of the band shroud. Secure the clamp part with tape to the band
shroud. Repeat to install the additional three worm screw clamp parts into the
second rectangular hole on this end of the band shroud.
D.
A. Shroud rectangular hole
B. Worm screw clamp part
C. Worm screw nut part
D. Shroud guide pin and guide pin hole
A.
B.
C.
