Maintenance and Troubleshooting Manual
Section 3: Meter maintenance
3-9000-764 Rev F
December 2017
Transducer cable removal and installation
33
29.
If required, install the security seal wire into and through one of the two holes in the
end cap. Choose holes that minimize counterclockwise rotation of the end cap when
the security wire is taut (maximum wire diameter.078 inch; 2.0mm).
Figure 3-19 Transmitter Electronics Enclosure security seals
30.
Adjust the security wire, removing all slack and thread into the lead seal.
31.
Crimp seal and cut wire ends to remove excess wire.
A.
A. Transmitter Electronics Enclosure end cap
B. Security wire seals
B.
