Emerson daniel 1500 series, User Manual

Page: 51 / 104

4 Prepare the turbine meter for use
Topics covered in this chapter:
• Lifting conditions
• Lifting requirements for personnel
• Configuration of the turbine meter
4.1 Lifting conditions
WARNING!
CRUSHING HAZARD
During turbine meter installation or removal, always place the unit on a stable platform or
surface that supports its assembled weight.
Failure to comply could allow the turbine meter to roll, resulting in death, serious injury or
equipment damage.
WARNING!
LIFTING HAZARD
The lifting instructions are for installation and removal of the Daniel Liquid Turbine Meter only
and do not address lifting the turbine meter while it is attached or bolted to piping.
Failure to comply with these instructions may result in death, serious injury, or equipment
damage.
CAUTION!
FORKLIFT HAZARD
Do not insert the forks of a forklift into the bore when moving the turbine meter.
Inserting the forks may cause the meter to become unstable, resulting in serious injury or
equipment damage.
Lifting and installation conditions Table 4-1:
Conditions Description
Lighting and ventilation Install the turbine meter in a well lit and ventilated location, not
less than one meter (approximately three feet) from source of ig-
nition or source of heat which might damage the unit.
Prepare the turbine meter for use
User manual 41