14
Installation, Operation and Maintenance Manual
MAN-02-10-93-0700-EN Rev. 0
May 2019
Section 6: Field Setup Using MPA Config Software
Field Setup Using MPA Config Software
Figure 10
The Network SetUp changes configuration only for the network ports. It does not affect
the RDM port. If a pipeline is not connected to any one or more ports, or if it is desirable to
skip any one or more ports, click on the “Delete Port” number. The deleted ports will be
skipped when a next port command is issued in either local or remote control modes.
NOTICE
When configuration changes are made, click the “Write” button at the bottom of the
screen to transfer the new parameters to the actuator. The “Read” button may be used to
refresh the screen to verify the parameters have been properly written and stored in the
actuator. Do not turn off power for at least 10 seconds after changing configuration to
allow the actuator to write the new configuration parameters to EEPROM.
