User Instructions
MAN-02-04-60-0350-EN Rev. 3
February 2019
48
Section 7: Parameter Menu
Parameter Menu
Table 15.
Binary Outputs Parameter Group (3)
Menu
Item
Sub Menu
Item
Poss. Setting
Notes / Comments
P10.1
Binary
Output
Output 1
47: Pos.=Int2
Position = Intermediate position 2. The width of the
interval is set with the parameter P8.6
48: Pos.=Int3
Position = Intermediate position 3. The width of the
interval is set with the parameter P8.6
49: Pos.=Int4
Position = Intermediate position 4.The width of the
interval is set with the parameter P8.6
50:
Pos.=EmergPos
Position = emergency position. The width of the interval
is set with the parameter P8.6
51: Bus Bit 1
In existing bus interface (hardware option) the output is
set according to the selected bit bus.
4)
52: Bus Bit 2
53: Bus Bit 3
54: Bus Bit 4
55: Bus Bit 5
56: Bus Bit 6
57: Bus Bit 7
58: Bus Bit 8
59: Virtual 1
Configurable output function
60: Virtual 2
61: Virtual 3
62: Virtual 4
63: Line voltage OK Supply voltage for the motor is OK
64: Control
voltage OK
The auxiliary voltage for the SMARTCON control is OK.
This function is only available if the auxiliary voltage
output is not switched on (P6.5 to 0)
65: Oil
pressure OK
The oil pressure is higher than the minimum pressure (P6.10)
66: Oil level OK The oil level is OK
67: Pump OK
The temperature sensor in the pump motor and the
external motor protection have not tripped
4-5
P10.2
Output
conf. 1
normal
Output 1 is set to normal, i.e. if the condition in point
P10.1 is met, Output 1 is set to HIGH (active HIGH)
inverted
if the condition in point P10.1 is met, Output 1 is set to
LOW (active LOW)
norm. flashing
if the condition in point P10.1 is met, Output 1 starts
blinking (active HIGH)
inv. flashing
if the condition in point P10.1 is not met, Output 1 starts
blinking (otherwise it is set to HIGH)
P10.3
Output 2
see Output 1
---
P10.4
Output 2 Konf. see Output 1 conf. ---
P10.5
Output 3
see Output 1
---
P10.6
Output 3 Konf. see Output 1 conf. ---
P10.7
Output 4
see Output 1
---
P10.8
Output 4 Konf. see Output 1 conf. ---
P10.9
Output 5
see Output 1
---
P10.10
Output 5 Konf. see Output 1 conf. ---
P10.11
Output 6
see Output 1
---
P10.12
Output 6 Konf. see Output 1 conf. ---
P10.13
Output 7
see Output 1
---
P10.14
Output 7 Konf. see Output 1 conf. ---
P10.15
Output 8
see Output 1
---
P10.16
Output 8 Konf. see Output 1 conf. ---
4)
from Firmware 1.323
