EMCS User Guide
- 15 -
6.2 Programming Details
Lift the handset and touch <WAKE> to turn on the keypad and illuminate the “WAKE”
LED or call into the Consolidator from a remote location (on- or off-site) (see next
section for remote programming). Touch <PROG> to enter program mode and turn-on
the “PROG” LED. The operator prompt
“Program”
will be heard.
Touch the key(s) to select the command number required, touch <ENTER> and listen
for the prompt to confirm the command. Input the parameter and touch <ENTER>. The
prompt “
Input accepted
” will be heard if the parameter qualifies or “
Incorrect entry,
please re-enter
” if not. To check any entry, touch the command number followed by
<REPLAY>. Touch <CANCEL> to exit a command without changing the parameter.
Touch <EXIT> or hang-up the handset to leave programming mode. An audible alarm
will sound if the handset is off-hook too long without activity.
REPLAY
To check the current value of any parameter, enter the command number followed by
the <REPLAY> key. For example, to hear the main firmware version, press the <7> key
followed by <REPLAY>. One will then hear the message “
Firmware version
” followed by
the digits representing the firmware version installed on your unit.
6.2.1
Command # 1: LEARN MODE
Learn mode automatically configures and verifies the wired communication system. The
Consolidator first checks the number of valid phone lines wired to the system and
announces the operating modes available for selection. Then the Consolidator searches
for all cab phones connected to the system and displays the status of each phone as a
colour on the corresponding station icons. Cabs which exhibit unacceptable behaviour
are flagged
RED
for failed and trigger a Phone Line Monitoring (PLM) alarm in their
group.
Enter Learn Mode through the programming menu or by touching the <LEARN>
shortcut key. The voice prompt “
Learn Mode
” will be heard, followed by a choice of
available operating modes based on the wiring configuration. Touch the digit
corresponding to the desired mode followed by <ENTER> to confirm. The voice prompt
“
Configuration complete”
will be announced at the end of the process. Hang-up.
Voice Prompt:
“
Learn mode”
