Introduction
Integrating a Cisco IP phone with Ooma Office is quick,
and can be accomplished in just a few simple steps.
By following the instructions below to provision the
phone, you can put it into service immediately without
any manual configuration.
Cisco IP phone
Ethernet cable Power adapter
In order to get started, you must first
register the Cisco IP phone to your
Ooma Office account. You can do this by
visiting the following URL and following
the steps on the screen:
http://office.ooma.com/add_ip_phone
Step 1
Register Phone Online
Package Contents
Cisco IP Phone
Quick Installation Guide
Use the Ethernet cable that came with the phone to connect the
SW
port on the back of the Cisco IP phone to an available wired
Internet connection.
The start up process will take several minutes, during which the
IP phone may restart a few times.
Once the line buttons on the right side of the display screen light
up green, the Cisco IP phone is ready to place and receive calls!
Step 3
Start Up Phone
Step 2
Assemble Phone
Follow the instructions in the phone’s user manual to assemble
the phone and connect the power supply.
710-0150-200
Ooma-Insert-Cisco-IP Phone-Bilingual Aug 2016-R2.indd 1
8/16/16 4:39 PM
