48
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a NetWare Server
Initializing the Storage System
Change the Management Network Parameters and User Account Settings
If you need to change the management network parameters or user
account settings after you initialized the storage systems, you must
◆
Shut down the storage system.
◆
Reset the storage system.
◆
Rerun the initialization utility to set the parameters.
To Shut Down the Storage System
You can shut down the storage system with Navisphere Express or
the power switch.
To Start Navisphere Express
1. Open an Internet browser, such as Internet Explorer or Netscape,
on the server or on any host on the same LAN as the storage
system.
2. Enter the IP address of an SP in the storage system.
This address is the one you assigned when you initialized the storage
system.
If Navisphere Express does not open, make sure that the storage
system is not rebooting. When the reboot is complete, the
SP Boot/Fault light on the back of each SP is off and not blinking.
If the storage system is not rebooting and Navisphere Express still
does not open, go to the "Troubleshoot" section on the AX100
support website or the
AX100-Series Documentation
CD.
3. Log in to Navisphere Express by entering the username and
password that you specified when you initialized the storage
system.
To Shut Down the Storage System with Navisphere Express
1. In the Navisphere Express navigation pane under
System
, click
Service
.
2. In the
System Shutdown
page, click
Shutdown
.
To Shut Down the Storage System with the Power Switch
Press the power button down for about a second.
