36
AX100-Series - Installing a Fibre Channel Storage System with a Direct Connection to a NetWare Server
Connecting ac Power to an AX100 Storage System
The first time you connect the storage system to an ac power source,
it immediately begins to power up: BIOS, POST, and operating
system boot. The green power lights (LEDs) on the front and back of
the storage system turn on and remain on as long as power is applied
to the storage system (Figure 14). The amber SP Boot/Fault light
flashes to indicate powerup progress. The Disk Activity lights on the
front of the storage system light intermittently as the disks spin up
and disk I/O begins.
When powerup is complete (usually in 5-6 minutes), the SP
Boot/Fault light goes off. If the storage system does not power up
within several minutes, refer to the
"Troubleshoot"
section on the
AX100 support website or the
AX100-Series Documentation
CD.
Figure 14
AX100 Storage-System Lights (LEDs)
If the amber System Fault light is on after powerup, a fault exists
somewhere in the storage system. If the amber light specific to a
power supply, SP, or disk is on, then that part is faulted.
Fault
Disk Activity
EMC2934
Power
Front Lights
FE 0
FE 1
FE 0
FE 1
Power
SP A Boot/Fault
Power Supply A Fault
Power Supply B Fault
SP B Boot/Fault
EMC2928d
SP B
SP A
Rear Lights
