EMBRON Hatteland Technology 1 G2 Series, User Manual

Page: 52 / 128

52 User Controls
IND100064-72
Multi-PIP Settings
Lets you adjust how the Picture-in-Picture (PIP) or Picture-by-Picture (PBP) display modes are set up. The
default position of the rectangle is set to the upper left corner of the Active Display area. Note that this
requires a valid incoming signal to be present in any of the "DVI", "DisplayPort", "VGA" or "Composite"
inputs. The contents of these submenus are listed below.
Valid combinations of Picture-in-Picture (PIP) and Picture-by-Picture (PBP):
Gray = Same. Red = Not possible. Green = OK .
Main > DVI1 DVI2 VGA1 VGA2 Composite1 Composite2 Composite3 DisplayPort
Second
DVI1
DVI2
VGA1
VGA2
Composite1
Composite2
Composite3
DisplayPort
|---2---
Multi-PIP Settings - PIP Mode
Settings as follows:
"PIP OFF" = Function is inactive and other settings can not be accessed.
"PIP Child"
1
2
The Secondary Source will be displayed in a small frame as an overlay over the
Main Source signal. When this function is activated a new menu item will appear
under "PIP Mode" called "PIP Display". Known as "Picture-In-Picture (PIP).
"PIP Split"
1 2
The Main Source and Secondary signal sources are shown side-by-side with the
Main Source to the left and the Secondary Source to the right.
Note: Both sources will be stretched to fill screen. If aspect ratio is needed,
consider PIP Wide function below, or set the sources to match 50% resolution
of the native display. Example: If native TFT panel has 1920 x 1024 resolution,
sources must be set to 960 (wide) x 512 (height) to appear correctly (aspect ratio).
"PIP Wide"
1 2
The Main Source and Secondary signal sources are shown side-by-side in
widescreen mode with the Main Source to the left and the Secondary to the right.
Aspect Ratio of souce signals are preserved.
● Note: Default is OFF
OSD Menu Functions