P7 OPERATION PROCEDURE
4. OPERATION PROCEDURE
4.1 POWER UP
Plug in power and the pump will do self-diagnostic checking.
1. If there is error, it will display as below, call you installer or dealer to fix the problem.
2. Normal display is as below and use
▲
“
“ “
▼
“buttons to adjust the speed (SP) in RPM.
3. Short press “Mode” again will display the power consumption (P) in Watt.
4. Short press “Mode” again to display the clock (CL)
4.2 CLOCK SETTING
1
.
Long Press “Mode” to access clock setting.
2
.
Short press “Speed 1 “and “Speed 2” to shift between Hour and Minute. The adjustable value digital is flashing.
3
.
Press “
▲
” or “
“ to adjust the value.
4. Short press “Mode” to save setting or press “Speed 3” for cancel.
5. Then it exist clock setting.
▼
WI-FI SETTING P16
Page 1
Page 2
1
.
Touch the “SYNC” to set the pump clock , the pump will follow the clock of your Wi-Fi device.
2
.
Speed 1-4 speed setting is done by slider or direct enter the speed box.
3
.
Speed 1-4 can be renamed as user prefer in less than 10 characters.
4
.
Schedule 1-4 can set Time On and OFF duration and among Speed 1-4. Schedule can be renamed as user
prefer in less than 10 characters. There is enable and disable switch at the end of each setting to turn it ON or
OFF.
5
.
Freeze protection default temperature is 4 degree C in 4 or 8 hours running in setting speed.
6
.
To do any change, touch save to store the change before back to home page.
11.4 CHANGE SSID AND PASSWORD
The SSID and Password can be changed by typing the IP address 192.168.8.1:88 to access the Wi-Fi Network
setting page. It is similar to what people do for their home router.
Type SSID name and password, repeat the same password, then press “Submit”.
The EPV Wi-Fi SSID and password is changed and you need to re-connect the EVP Variable speed pump Wi-Fi by
new assigned SSID and Password.
Scan QR code or type IP address 192.168.8.1 to access the web ser ver page again.
Language pull down selection
Wi-Fi Valid connection display
Setting page link
Flow Rate display
Pump Run / Stop button
Power rate display
Speed Input
Touch the screen
for update
speed 1~4 selection
button
PUMP STATUS
Enabled
Schedule display
Status display
- Priming
- SRVS
- Freeze protection
- Fault message
- ...
Enable / Disable
switch
Enable / Disable
switch
Slide or type to set
Speed 1-4
Re-namable
Speed 1-4
Re-namable
Schedule 1-4
Running time
4/8 hrs selection
SAVE button for
any change update
Slide or type to
set Speed
Go to page 1
Time of your Wi-Fi Device
Press to write time to EPV
