OPERATION PROCEDURE P8
4.3 PRESET SPEED 1-3
1
.
There are three preset speed, press Speed 1, Speed 2 and Speed 3 to change the pump speed.
Speed 1 = 1500 RPM
Speed 2 = 2400 RPM
Speed 3 = 3400 RPM
4.4 CHANGE PRESET SPEED 1-3
1
.
Press “Speed 1” and long press “Mode”. The four digital speed value will flash.
2
.
Press “
▲
” or “
▼
” to adjust the speed.
3
.
Short press “Mode” to save setting or press “Speed 3” for cancel.
4
.
Repeat above for Speed 2 and Speed 3 setting.
4.5 SETTING SCHEDULE
When the display back to SP:1000. (Current speed display)
P15 WI-FI SETTING
11. WI-FI SETTING
EPV series VS pump Wi-Fi version with control interface build in to control the pump over Wi-Fi in Wi-Fi Direct ONE
to ONE and Home Network .
11.1 ENABLE WI-FI CONNECTION
1
.
Connect to AC power and Power on EPV variable speed pump by “Run” button after proper piping installation.
2
.
The pump will start self-pumping and Wi-Fi icon should display next to the clock in few minutes.
3
.
If there is no Wi-Fi icon display, press the “MENU” button and roll down to items 10 by “
▼
”
, press “ENTER” to
access Wi-Fi setting.
4
.
Press “FUNCTION” to display the selection.
5
.
Press “Enabled” by pressing “ENTER” and “ESC” to go back to home display.
11.2 Wi-Fi Direct CONNECTION
EPV Wi-Fi Direct connection is a ONE To ONE connection without access Home Network . It is just like a private
controller. It can be connected and control by mobile phone, tablet PC, laptop top or any Wi-Fi enable devices
directly without computer operation system concern. The user interface support most of the popular web browser.
1
.
Go to Wi-Fi setting of mobile phone and find “EPV SPV-WiFi” and enter password VS PUMP for connection. This
is the factor y default SSID name and password.
2
.
Scan the QR code label on the side of the controller unit, it will access the EPV user interface and the browser
show “EPV PUMP.com” which is a virtual domain name without internet connection.
3
.
Or, by typing IP address 192.168.8.1 to access.
”
”
11.3 APPLICATION INTERFACE
The user interface can do all the EPV setting and programming as the control panel on the pump, along with status
display. It easy and comprehensive to use.
1
.
Touch the “Run/Stop” button to switch the pump ON/OFF.
2
.
Touch the speed “number, 2500”, enter the speed and touch any location of screen for enter. The pump will run at
new speed.
3
.
Press S1-S4 to select the preprogram speed.
4
.
Pump running status, schedule status and error code display at the bottom.
5. Touch the SETTING icon to enter setting page
6
.
Touch “English” next to Emaux logo to select language. The control page support languages in English, French,
German, Italian, Spanish, Russian and Chinese.
Wi-Fi Direct
