MES3000 Ethernet switch series
49
delete
url
-
Delete the file from the device flash memory.
*.prv, image-1 and image-2 files cannot be removed
.
delete startup-config
-
Delete the initial configuration file.
boot system [unit
unit
]
{image1 | image-2}
unit (1..8)
Define the system firmware file, that will be loaded on startup.
- unit—number of the device in a stack (for standalone switch, this
parameter is not used)
show {startup-config |
running-config} [aaa | acl |
dhcp | eaps | ip-address |
channel-group | multicast |
management | selective-qinq |
qos | routing | snmp | sntp |
syslog | spanning-tree | vlan |
interfaces [gigabitethernet
gi_port
| tengigabitethernet
te_port
| port-channel
group
|
vlan
vlan_id
]]
gi_port: (1..8/0/1..24);
te_port: (1..8/0/1..4);
group: (1..24);
vlan_id (1..4094)
Show contents of the initial configuration file (startup-config) or
the current configuration file (running-config).
To reduce the amount of shown data, you can select a specific
configuration section.
List of existing configuration sections:
-
aaa
—authorization, authentication and accounting (AAA)
parameter settings
-
acl
—access list configuration
-
dhcp
—DHCP server, DHCP relay function configuration
-
eaps
—EAPS protocol configuration
-
ip-address
—IP interface configuratiion
-
channel-group
—port group (port-channel) configuration
-
multicast
—multicast routing configuration—IGMP Proxy, IGMP
Snooping
-
management
—device management and access configuration for
web, SSH, Telnet services
-
selective-qinq
—Selective Q-in-Q configuration
-
qos
—QoS parameter configuration
-
routing
—configuration of static routing, RIP, OSPF protocols
-
snmp
—SNMP configuration
-
sntp
—SNTP configuration
-
syslog
—syslog configuratiion
-
spanning-tree
—configuration of Spanning Tree family of
protocols
-
vlan
—VLAN configuration
-
interfaces
—configuration of the switch interfaces—physical
interfaces, interface groups (port-channel), VLAN interfaces
show
bootvar
[
unit
unit
]
unit (1..8)
Show the active system firmware file that device loads on startup.
- unit—number of the device in a stack
Parameter
unit
is available in the stackable mode only.
write [memory | terminal]
Save the current configuration into the initial configuration file.
rename
url new_url
url, new_url: (1..160)
Change the filename.
- url—current filename
- new-url—new filename
There are some forbidden combinations of location and destination. Copying is impossible in
the following circumstances:
–
If source and target files are the same
–
X-modem cannot be used as a destination. Using X-modem, you can copy the
file from the source address into the system firmware file, startup file or null
–
TFTP server cannot be used as source address and destination address for a
single copy command
–
*.prv files cannot be copied
–
Copying from/to the stack devices operating in the slave mode is possible only
for the system firmware file and the load file
Table 5.21 —Copy indicator description
Indicator
Description
!
Exclamation mark means that the copying process is going smoothly. Each exclamation
mark indicates successful transmission of ten packets (512 bytes each).
.
Dot means that the copying process was interrupted. Multiple dots in succession mean
that the error occurred during the copying.