29
Setting the parameters
Room Temperature Controller KNX eTR 101-BA2
• Version: 20.04.2021 • Technical changes and errors excepted.
Standard inverted:
When pushed shortly, the drive moves up to the end position. When pushed for longer,
the drive moves incrementally or stops. The time difference between "short" and
"long" and the repeat interval is set individually.
Comfort mode:
In the
comfort mode
actuating the button briefly, a bit longer and long will trigger dif-
ferent responses of the drive. The time intervals are set individually.
Short actuation
(shorter than Time 1): The drive is positioned step-wise and stopped.
Holding it slightly longer
(longer than Time 1, but shorter than Time 1+2): Drive run-
ning. Drive stops when the button is released.
Long holding
(release after Time 1+2 runs out): Drive moves independently to the end
position. The movement can be interrupted by a short tap.
Behavior during button operation:
short = stop/increment long = Up or Down
Time between short and long
in 0.1 seconds
1...50; 10
Control mode
Standard inverted
Behavior during button operation:
short = Up or Down long = Stop/Step
Time between short and long
in 0.1 seconds
1...50; 10
Repeat the step command
for a long button press
every 0.1 s • every 2 sec; every 0.5 sec
Point in time 0:
Actuate of button, start of time 1
Release before time 1 expired:
step (or stop if drive is moving)
Point in time 1:
End of time 1, start of time 2
Moving command
Release after time 1 expired
but before time 2 expires:
Stop
Release after time 1 + 2 expired:
Move into end position
Control mode
Comfort mode
Time 1
Time 2
0
1
1 + 2
Fig. 2
Time interval comfort mode diagram
