Elliott Traffic Safety Service L60, Operator'S Manual

Page: 22 / 212

ANSI/SIA HiReach EEC-0144 V1.3
Responsibilities per
ANSI/SAIA A92.2
Should the original manufacturer no longer exist an equivalent entity may determine
the required procedure.
1. Maintenance Training: The owner shall train their maintenance personnel in
inspection and maintenance of the aerial device in accordance with the
manufacturer’s recommendations and
Section 8 of this standard.
E. Modifications: No modifications or additions which affect the stability,
mechanical, hydraulic, or electrical integrity or the safe operation of the aerial
device shall be made without the written approval of the manufacturer. If such
modifications or changes are made, the capacity, operation, and maintenance
instruction markings shall be changed accordingly. In no case shall the safety
factors be reduced below those specified in this standard or below the
manufacturers design safety factors, whichever are greater. Should the original
manufacturer no longer exist, an equivalent entity may approve required
modification.
F. Weight Distribution: Changes in loading or additions made to the mobile unit
after the final acceptance that affect weight distribution shall meet applicable
regulations by governmental agencies. In no case shall axle loads of the fully
loaded vehicle exceed the Gross Axle Weight Ratings (GAWR) assigned by the
manufacturer. Note: Any change in weight distribution may adversely affect
stability.
G. Transfer of Ownership: When a change in ownership of an aerial device
occurs, it shall be the responsibility of the seller to provide the manufacturer’s
manual(s) for that aerial device to the purchaser. It is the responsibility of the
purchaser to notify the manufacturer of the unit model and serial number and the
name and address of the new owner within 60 days.
H. Markings: The markings on the aerial device shall not be removed, defaced, or
altered. All missing or illegible markings shall be promptly replaced.
I. Parts: When parts or components are replaced they shall be identical in
specification and function to the original aerial device parts or components or
shall provide an equal or greater factor of safety.