Elliott Traffic Safety Service L60, Operator'S Manual

Page: 55 / 212

Operating Controls Hi Reach Lower EEC-0099
V1.3
Operating Controls-HiReach
Down- Digger operates at low speed
F.
Master Switch – Emergency Stop Switch
Switch Master Switch to “ON” position, to operate HiReach. Switch Master
Switch to “OFF” position to disable HiReach.
G. Control Switch
Up- Switch control to platform controls
Down- Switch control to turret controls
NOTE: Turret controls are for material handling with the boom winch only. These
controls shall not be used with personnel in platform unless personnel in
platform are unable to operate upper controls.
H. Emergency Pump Switch
Up- Momentary switch that activates emergency pump. Hold switch to operate
pump functions.
Down- Release momentary switch to neutral (off) position to stop emergency
pump.
I. Chassis Engine Speed Control Switch
Up- press switch to increase truck engine speed to high setting.
Down- press switch to decrease truck engine speed to idle setting.
J. Truck Start Switch
Up- Press and hold to activate the truck engine. Release the switch as soon as
the engine starts.
Down- Press and hold to shut the truck off. Once the engine stops completely
stops running, release the switch. If this switch is released while engine is
still turning over, the truck will restart.
Boom Angle Indicators
Located on either side of base boom-indicates the angle of the boom (in degrees)
above or below horizontal.
Boom Length Indicators
Located on the top of the cable carrier horizontal tube. The numbers correspond with
the boom length in feet.