Installation and use MR16
15
4 – INSTALLATION
4.1 RADIO MODULE MR16
4.1.1 Fastening
1. Open radio module MR16 as illustrated in figure 2.
Figure 2
2.
Prearrange passages for cables of connection to wired alarm control panel.
Radio module container base is prearranged with pre-fractured passages (figure 3): if rear
passages and not side passages are to be used, first remove the electronic board, taking off the
four screws that are placed at the corners (figure 4).
Figure
3 Figure
4
3. Secure radio module to a flat wall, using fixing plugs supplied. Figure 5 shows possible
alternatives:
•
Hanging from slot
A
and then blocked by holes
B
and
C
. In this case, the electronic board
has not to be taken off.
•
Secured to an embedded box with 3 modules, using holes
D
.
•
Secured to an embedded box with 2 modules, using two holes
E
.
Warning:
to assure antiremoval protection to radio module, hole
C
must always be used too.
