Elkron MP 200, Installation And Maintenance Manual

Page: 14 / 32

MP200 Installation Manual
14
M6 TERMINAL BOARD
+ Positive sensor power supply
- Negative sensor power supply
Z7 Zone 7: programmable input
Z8 Zone 8: programmable input
T/A Tamper/self-protection input balanced positive via an R =15Kohm.
M7 TERMINAL BOARD
+ Positive sensor power supply
- Negative sensor power supply
Z4 Zone 4: programmable input
Z5 Zone 5: programmable input
Z6 Zone 6: programmable input
M8 TERMINAL BOARD
+ Positive sensor power supply
- Negative sensor power supply
Z1 Zone 1: programmable input
Z2 Zone 2: programmable input
Z3 Zone 3: programmable input
M9 TERMINAL BOARD
- Reference negative
KEY Electromechanical key input
Note: this dedicated input (not programmable) may be connected to an
electromechanical normally open push contact key. Each complete sequence:
open - closed - open of the key contact causes a total system status change
(of all sectors). If this input is not used, it may be left free and with no special
device.
M10 TERMINAL BOARD
- Device power supply on serial tamper input will be
LA serial data line
LB serial data line
+ Device power supply on serial line
M11 TERMINAL BOARD
Support terminal board for service keypad (in parallel with BUS1 terminal
boards). To allow programming with a service keypad without disconnecting
peripherals already connected.
M 6
M 7
M 8
M 9
M10
M11