Elite Greenhouses KENSINGTON 10 x 6, Manual

Page: 30 / 40

5 BLADE LOUVRE
Procedure
1. Place top cill into position on side jamb
of louvre and secure with self tapping
screws.
2. Do same on the other top corner.
3. Do same with bottom cill.
4. Please note that the handle is on the
right hand side, the above diagrams are
viewed from the middle.
5.To fit the louvre to the side, utilise the
extra bolts you inserted during side frame
assembly. Insert a glass pane at the bot-
tom, bolt the louvre to the framework and
slide it down so that the bottom cill of the
louvre frame is touching the pane of glass.
With the louvre in the open position, insert
the 5 glass blades from the inside. Insert
the upper pane above the
louvre.
The louvre can be installed to either the fixed gable end or front assembly. This position might not
be variable depending upon your door position.
1.
The louvre must be fitted after the unit has been fully assembled and anchored to the wall and
base, and prior to glazing.
2.
The louvre is fitted to the wall bar and glazing bar of the fixed gable end utilising the 4
unoccupied bolts previously inserted into the bolt slots of the glazing bars concerned during original
assembly.
3.
The louvre is fitted from the inside of the structure with the angle jambs fitting around the
glazing bar. N.B. The handle is on the inside of the greenhouse and the right hand side as viewed
from inside the structure.
4. To determine the height, install a pane of glass under the louvre (glass size dependant upon
style of glass and desired louvre height) see relevant glazing plan.
5. Offer the louvre frame to the bolts; add the nuts and finger tip tighten.
6.
Slide the completed framework to the top of the pane of glass so that the bottom cill of the
louvre rests on the glass.
7. Tighten all nuts. Louvre frame installation is now complete.
INSTALLATION OF 5 BLADE LOUVRE TO THE STRUCTURE