Elite Greenhouses KENSINGTON 10 x 6, Manual

Page: 13 / 40

The next addition to the rear end (non-door end)
is the aluminium shelf. The following diagram
and text give the details of its installation. The
shelf is to be fitted to the rear end of the unit.
1.
Attach the fixing braces on to all 3 bars using
the lower of the unoccupied nuts and bolts at
the desired height. (Ensure that all braces are
fixed at the same height).
2.
The shelf rests on the upper of the unoc-
cupied bolts (nuts now not required) which is
held in place using the fixing clamps as seen in
the diagram. Again,
ensure that the fixing clamps are fixed at the
same height.
3.
The shelf is further supported by
the insertion of the fixing brace in to the pro-
truding lip of the underside of the shelf as seen
on the diagram.
4. Ensure that all nuts are tight. Do not over
tighten.
LEFT HAND GABLE END FRA
ME
Please note that for the purpose of this plan, we have made the left hand gable, the door end, but it
could just as easily be the right hand gable end. So please read this section and the preceding one
with the alternative in mind.
From the main box you will require:
1. Set of corner bars marked LEFT HAND END CORNER BARS.
2. Set of glazing bars, angle and cill marked END.
This contains:
1. Wall bar
2. Door cill
3. Glazing bars
4. 1 Horizontal bracing angle
3. Set of angles marked DOOR END.
From the bag of assorted fittings and fittings within the box, you will require:
1 One eave gusset plate
2 Nuts and bolts
3 Coil of glazing bead
SHELF INSTALLATION