Eliet Maestro City Electro, Manual

Page: 52 / 54

52
English
Now you can loosen the engine mounting plate from the
frame. To do so, loosen the four M8 bolts completely. The
engine and its fixing plate are no longer attached to the
chassis.
Once the clamping force is gone, you can slide the blade axle from the crankshaft. Grab the blade
axle between two blade plates at it’s core, en hold it up. Now slide the engine away to the left, so
that the crankshaft is completely out of the hub of the blade axle.
Remove the blade axle from the machine by the output zone
Check if the nylon support ring doesn’t show any signs of wear. Replace it if needed: Item
number: MPA 01 221 470 .
When reassembling the blade shaft be ensured that the nylon support ring is already mounted on
the shaft end of the blade shaft before reinserting it in the shredding chamber.
Now slide the crankshaft of the engine in the hub of the blade shaft until it is clamped on the
tapered shaft. Tighten the clamp bolt back in to the central part at the end of the blade shaft.
Tighten this clamp bolt securely (wrench 13).
Now reassemble the nylon support ring and screw it tight. Caution: Do not put to much tension
on the screws so that the screw thread doesn’t tear.
Place the rubber cover back into the opening.
Now shift the engine so that the blade shaft is central in the shredding room, and the distance
between the two outer knives is equal on both sides.