1
1
2
51
English
16.3 Removing and reinstalling the blade shaft
Caution:
Always switch off the engine prior to removing the blade shaft.
Warning:
To perform this maintenance, you are exposed to the blades. Protect yoursefl
against the risks and wear safety gloves.
Before removing the blade axle, slide the collecting bag out of the machine and remove the sieve
(“read § 16.3 Removing and reinstalling the blade shaft” on page 51)
If necessary, remove the chips from the shredding chamber.
The blade shaft is mounted on the crankshaft of the engine and is thus is borne by the engine. In
the case of the engine, the suspension of the blade depends on the model:
•
In the
Maestro City
the blade shaft is mounted directly on the crankshaft from the engine.
On the other side of the blade shaft is a bushing (opposite to the engine side) on the
Maestro City. This nylon bushing holds the blade shaft in place when it is under pressure or
when it`s pushed out of alignment. There is an air gap between the bushing and blade shaft
in normal operating position.
To disassemble the blade shaft, first dismount the nylon support ring City). To do this, loosen the
three (1) M8 bolts (key size 13) or the three M6 bolts (key size 10).
Remove the rubber protection cap (2) in the right side
of the shredding chamber to gain access to the central
clamping bolt of the blade shaft. Turn this clamping
bolt (key size 17) counterclockwise en remove it from
the machine.
Summary of Contents for Maestro City Electro
Page 1: ...M A N U A L Maestro City Electro...
Page 9: ...9 English 6 2 Engine electric 3000W 230V...
Page 54: ...BZ 201 223 003...
