62
English
13.7.2 Drain hole in the collector
• The collector is equipped with a small hole underneath to drain away water and fi ne debris that
is not transported by the screw. However, this hole can become blocked.
• Insert a thin nail into the hole in order to unclog it.
13.7.3 Sealing of the radiator grill
• It is important that dirt does not stick to the radiator so that a continuous fl ow of air is main-
tained.
• In order to prevent dirt from entering via the joints, the housing for the radiator is sealed as
much as possible.
• Thus regularly check whether the rubber sealing strips are still correctly mounted and whether
they form a perfect seal against the large safety cover.
13.8 General lubrication
Since the shredders often operate in extreme conditions, Eliet only uses high-quality materials.
ELIET therefore uses special lubricants as from the early stages of the assembly.
The following parts require regular lubrication :
Hinge points and surfaces that can create friction. (see 13.8.1).
Lubrication nipples (see 13.8.2)
Bearings (see 13.8.3)
Chains and gearwheels (see 13.8.4)
Caution :
Before performing the lubrication, you must switch OFF the engine and remove
the key from the starting lock. Gloves are also mandatory for this maintenance.
13.8.1 Lubricating the hinge points
This group, for example, includes the following points on the machine :
• Hinge of the handlebar
• Locking pin of the handlebar
• Hinge points of the handle for the wheel drive
• Hinge points of the front wheel steering
• Joint in the rod for the valve-operated wheel drive
• Ball joints of the front wheel drive rod
• Hinge point of the front wheel shaft
Summary of Contents for MA 018 010 130
Page 1: ...Megaprof M A N U A L...
Page 7: ...7 English...
