57
English
Rule : make sure that the rear of the blades in blade group 1 always point towards the side
walls of the shredding chamber.
In order to implement this rule consistently, perform the procedure below in a logical manner:
• Remove a blade from the left-hand blade disk, rotate it through 180° and fi t it in the same posi-
tion, but to the right-hand disk. Rotate the blade from the right-hand disk through 180 degrees
and then fi t it in the opening that appears in the left-hand disk. Repeat these steps until all 8
blades of both disks for group 1 are reversed and fi tted.
• Always clean the blades and blade holders before refi tting them.
13.2.2 Renewing the blades of group 2
(Blade pairs 1 and 2)
Rule : each blade plate has four positions. In two positions, an angled blade is fi tted, and in two
other positions, a straight blade is fi tted. The front of the angled blades must always point
towards the axis of the rotor. in the case of the straight blades, the front of one blade must
point to the right, and the front of the other blade must point to the left.
In order to implement this rule consistently, perform the procedure below in a logical manner:
• Disassemble two blades that are mounted diametrically opposite each other. Turn them through
180° and interchange them. Now do the same with two remaining blades. Repeat this for the
three remaining blades of group 2.
• Always clean the blades and blade holders before refi tting them.
Summary of Contents for MA 018 010 130
Page 1: ...Megaprof M A N U A L...
Page 7: ...7 English...
