Eliet Edge Styler, Manual

Page: 23 / 76

23
English
8.2 Assembly instructions for the Edge Styler STD
• Place the lower part of the steering rack onto
the machine. Screw threads are present in four
places on the lowest part of the rack for fasten-
ing onto the main body. Use the four M8 X 40
bolts for attaching the pinions (key size 13).
• Whilst tightening the tube, proportionally apply
tightening force so as to avoid crushing the tub-
ing of the steering rack.
• Now, slide the red dead man’s handle onto the
right-side tube-opening of the steering rack.
• Next, slide the black handle onto the left-side
tube-opening of the steering rack.
• Adjoin the upper and lower parts of the steer -
ing rack by placing the plastic connector joints
located on each side of the upper tube into the
open ends of the lower one.
• Use a plastic hammer to tap on either side of the
upper steering rack such that the two plastic con-
nector joints become completely seated in the
lower tube.
• Fasten both sides of the upper tube with a screw
so as to affix the upper part of the steering rack
onto the connectors.
• Now, add the red dead man’s handle, ensuring
that it is pointed ”upwards“ at a distance of 15
mm from where the tubes connect. Rotate it into
place until tightly fitted onto the steering rack us-
ing the bolt on the right side of the handle (Allen
key 5).
• Place the small, barrel-shaped object at the end
of the cable (leading from the transmission box)
in the opening of the red handle. Now, put the
adjustment screw at the end of the cable line
through the opening of the lever.
• Feed the lined cable through the opening of the
machine and pull it through to the lever that
operates the transmission.
• The S-shaped end of the cable is hooked onto
the second lever. When pulling on the cable, one
lever should tug on the other along the same path.
• Place the cable lining in the opening of the transmission box.