Eliet Edge Styler, Manual

Page: 55 / 76

55
English
• Cover for the foot pedal.
- Make sure the motor is off and that the blade carriage is in trans-
port mode.
- Using a wrench (number 10), the bolt on the side of the cover
should be removed.
- Push the cover slightly downwards so that the clip underneath the
chassis comes loose.
- After that, pull the cover slightly backwards so that the clip above
the traction tyre also comes loose.
- Remove the protective cover.
Safely tipping the machine
In some maintenance procedures, you will work on the underside of
the machine. When doing this, the machine should be tipped over and
supported in a safe manner.
• Make sure that you are standing approximately 50 cm from a wall.
• If preferred, cardboard may be placed underneath the machine,
which will protect your floor as well as avoid scratches on the ma-
chine.
• Tip the machine over its traction tyres so that it touches the ground
at the front side of the chassis.
• Continue to press the machine forward until it is resting against the
wall.
• Be careful that the dead man’s handle does not become clenched.
• Reposition the machine as necessary.
Tightening the belts
The Edge Styler is equipped with two belts. Both belts can become overstretched and show signs
of wear and tear after multiple uses. Even breakage can occur. If a belt becomes broken, it
should be replaced at an ELIET authorised dealer. If overstretched, the belt can be re-tightened
by following the procedures below.
• Tightening the blade driver belt.
- Make sure the motor is off and that the spark plug has been disconnected.
- Remove the protective cover from the blade carriage (read § 11.4.2.1. ).
- Under the cover, there is an extension spring connected to the connector rail.
- Disconnect the spring from the connector rail and reconnect it again, this time farther down
Warning :
The machine may only be tilted forwards. Tilting the machine in any other direc-
tion can cause motor fluids to flow through to other parts of the motor, which
can lead to further damage to components of the motor.