ELEKTRA Crema Caffe, Instruction Manual

Page: 48 / 68

48
ATTENTION: USA - CANADA REQUIREMENTS
- The equipment is to be installed with adequate backflow protection
to comply with applicable federal, state and local codes.
- Water and waste piping and connections shall comply with
the International Plumbing Code 2003, International Code Council (ICC)
or to the Uniform Plumbing Code 2003, International Association
of Plumbing and Mechanical Officials (IAPMO).
ADJUSTING THE FEET (A-K)
Place the machine on the work counter and ensure that it is level, by adjusting the length
of the feet.
Turn the chrome-plated foot counter-clockwise, when viewed from underneath, to lengthen
it and clockwise to shorten it. There are no screws or nuts to be loosened or tightened.
WATER CONNECTIONS (A-S-K-C-B, no A-K with WTS)
The water is fed thanks to a connection with the drinkable water supply at a minimum
pressure of 0.15 MPa (1.5 bar) and a maximum pressure of 0.6 MPa (6 bar).
Should the water supply pressure exceed 0.6 MPa (6 bar), install a pressure reducer upline
of the coffee machine / water softener system.
An external check-valve may be required to meet local regulations.
The machine has a flexible steel-braided connection pipe with a 3/8 female connection,
approx. 1.7 metres in length.
1) Connect the flexible pipe to the coupling located on the bottom of the machine.
2) If the machine is being installed without a water softener (not recommended unless
a centralized water softening system has been installed) connect the flexible pipe
to the water supply.
WATER CONNECTIONS (A-K with WTS)
The water is fed thanks to a connection with the drinkable water supply at a minimum
pressure of 0.15 MPa (1.5 bar) and a maximum pressure of 0.6 MPa (6 bar).
Should the mains pressure exceed 0.6 MPa (6 bar), install a pressure reducer upline
of the coffee machine / water softener system.
An external check-valve may be required to meet local regulations.
The machine has three flexible connecting pipes with 3/8 female connections,
approx. 1.7 metres in length.
1) Connect each flexible pipe to the couplings located on the bottom of the machine.
The three couplings are marked “1”, “2” and “W”.
2) Flush the water supply to ensure that it is clean and after couple to it the flexible pipe
coming from the “W” coupling.
Do not open the water supply.
INSTALLATION B
1
2
3